Taps Issues 2004 22V

[dlcork]

Having issue with the tap not seeming to work. twice the taps motor has just turned on when the boat was sitting in the shore station with the key off. Had to turn my perko switch to off to stop it. Then when I start the boat it doesn't always register at 8 on the taps gauge. When I press the taps switch to go to the 1 setting the gauge has a very jerky motion not smooth like it was before. So I got under the boat on the shore station and had some one turn the key on. The taps mad that sound like it was resetting but the plate didn't move. Has anyone experienced issues like this with their taps? Does this sound electrical? Is there a motor that may have gone bad that can be replaced? It has the hydraulic cylinder attached to the plate could that have gone bad? Any help/suggestions will be greatly appreciated.

Thanks Dan

[dom w. forte]

Is it a Lenco or Bennet, most common in 2004 was Lenco, there system after about 10 minutes of shut down would go back to wakeboard mode fully up , even if it was already up, this was normal, if its a Bennet then you have something wrong and would have to circut test.