Taps will adjust to 1 but after motoring along will move to #2 setting. Sometimes adjusting from 10 down to 1 it will stop at 3 and will only go down to 1 or 2 with several clicks on the adjustment switch. Pulled the boat out of the water and appears to have a frothy liquid coming from the cylinder attached to the taps plate. Is there a seal that holds the fluid in the cylinder? Do I have to replace the taps shock looking cylinder thingy (I know this is a funny description of the part) has anybody else experienced this or is this part available? Tige dealer is closed today, thought I may get an answer quicker posting this thread.
-
-
I have replaced mine because of leaking when it was under warranty. Low fluid from the leak would cause the problem you described. -
Thanks Aj, appreciate the information. Lucky you it was under warranty, I am sure I am past that avenue! I will contact my dealer and price it out.Comment
-
Check with Bennett, as they make the system. I've heard great things about their customer service, and most people with problems seem to be able to fix it themselves with just replacing a part or two. http://www.bennetttrimtabs.com/Comment
-
I did fix mine myself. My dealer is so far away I just had then ship me the cylinder. The one thing I learned is that the cylinder its spring loaded. Make sure the plate is all the way up before you disconnect the line or you will get an atf shower.Originally posted by dingleberry View PostComment
-
Thank so much to the both of you for the ideas and tips, I have sent an E-mail to the manufacture and will wait for their reply. Thanks again!Comment
Comment