Announcement

Collapse
No announcement yet.

I have a problem

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    I have a problem

    light on dash trans oil.stays on all the time oil is fresh and full to proper level on dip stick

    #2
    Does the panel just have an idiot light or a gauge also?

    Comment


      #3
      just idiot light

      Comment


        #4
        I would check the wires from the sender. If ok then replace sender. I believe that the light only comes on for high temp.

        Comment


          #5
          yes I cleaned the wires I had a felling that the sending unit is bad thanx

          Comment


            #6
            Hope thats the problem. Ths sender should't cost that much. Hopefully I can figure out my problem.

            Comment


              #7
              It says "Trans" but I believe it is actually for the V-drive fluid pressure. Are you able to check the fluid level with the boat sitting level in the water?

              Gotta ask......you are positive this was not a problem before the service and did you use the correct fluid?
              Mikes Liquid Audio: Knowledge Experience Customer Service you can trust-KICKER WetSounds ACME props FlyHigh Custom Ballast Clarion LiquidLumens LEDs Roswell Wave Deflector And More

              Comment


                #8
                One more thing, that light is supposed to be on for RPMs below 1000. Have you checked it at speed?
                Cursed by a fortune cookie: "Your principles mean more to you than any money or success."

                Comment


                  #9
                  yes all the fluids were changed I just got the boat this winter.its a good way to get to know your boat.

                  Comment


                    #10
                    once I idle away from the dock I lose myself I should check EH

                    Comment


                      #11
                      When we got our boat it was 6 years old and it had sat for 2 years.
                      The "TRANS" light (V-drive oil pressure indicator) was stuck on all the time, too.
                      The switch was gummed up inside.
                      Our V-drive is the Walter Gear Drive RV-26D, Ratio 1.46-1.
                      It uses a Hobbs Corp. - 76061 pressure sensor, 2 psi, NC.
                      Here's a spec sheet - http://www.fdrive.com.au/products/05/pressurep.php

                      Comment


                        #12
                        thanks for the info

                        Comment

                        Working...
                        X