Faria Gauge swap from VDO

[spharis]

All you PRExxxx owners wanting to get rid of your cracked VDO gauges that look like Austin Powers teeth....here's your part numbers.

***note, these part numbers are the chesapeake white face with stainless trim. The TAPs gauge is from about an 01-02 Tige' and matches the set; one other reason I chose these other than the look.***

Fuel Level - FAR 13801
Oil Pressure - FAR 13802
Temp - FAR 13804
Voltmeter - FAR 13805
Fuel Flow (replaced the hour meter on the right side) - FAR FFM002
Tach/hour meter combo - FAR 33832
2 speedos - FAR 33811

and the TAPs I got from Texas Tige'. It matches the above except as other have mentioned as well (even the factory set of these) the illumination is a little different.

It's part number is - #C2018

That should fill the dash. Every gauge was mostly a swap. Some had to have new power run or jumped, and almost all were able to remove some of the lighting wiring as it is a combo on the new instuments.

A very good source for these is www.boatersland.com; ocassionally you can get a package on ebay and save some money, but you will have some you do not need. This is a popular gauge style.

[TigeDuner]

They were very helpful when my Faria oil gauge sender went out. New unit in 4 days and fixed the problem.

[spharis]

Here's the VDOs






And After

[TigeDuner]

Looks like an '08 model. Great job.

[shane]

How much did it cost to replace all of them??

[spharis]

< $400

The only reason it was so much is the TAPs and the fuel flow are not cheap at all; $100 or so each.