If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I drilled a hole on each side under the seat to solve this same prob. Now if I could just get the inside of the hull to drain completely. I like my old 20i with the drain plug in the center. would be nice to have this option on the new on.
I have 03,21i with this problem.I took about a 1and1/2" drill and went thru the bottem inside rear of the front conpartments.My main concern was to drill into foam or hit the runners.Hole went thru no problem.I felt underneath and it is clear around the holes.I used the holes for the hose for ballest.
I don't know if this will work on your boat or not.it worked for me.
I had the same problem with my 21 i with the rollers and such but now when I have to turn around i almost stop the boat turn around at like 5 mph and no rollers, Nick showed me that one. Not sure how you can get rollers if you do do that though?
The only difference between stupidity and genuis is that genius has its limits.
I had the same problem with my 21 i with the rollers and such but now when I have to turn around i almost stop the boat turn around at like 5 mph and no rollers, Nick showed me that one. Not sure how you can get rollers if you do do that though?
Rollers from your boat aren't as much as a problem as rollers from another boat. Like if you go to the lake of the ozarks boats out there less than 26 feet are considered sunk. There are so many big boats on the main channel the almost need stop lights. Ok maybe not stop lights, but theres a ton of boats and your garuenteed to take a few over the front.
Common Sense is not so Common
Looking for fat chicks for long walks, romance, cheap buffets, and BALLAST.
I hear ya there. There are three people I trust to drive me, if one of them is not with us that day, I do not board. It kinda sucks sometimes, but oh well, I don't want a roller over my bow. Or worst, someone to catch a crab trap and mangle the prop shaft or rudder.
Rollers from other boats arent really a problem at my lake becuase there is not alot of bigs boats on it and its..spaced out I guess. In a busy lake I'm sure there a big problem though
The only difference between stupidity and genuis is that genius has its limits.
Comment