Boat shifts into gear perfectly, then as you go to pull up your rider up you keep increasing the throttle but nothing happens until suddenly it kicks in hard and takes off. The boat is new to me so I don't know how long it's been like that but it seems like it isn't registering the throttle movement until about 1/4 of the way through the throw. When it finally does register it seems to jump to 25% or more throttle.
My first thought was maybe a cylinder or 2 wasn't coming to life until 20% throttle but after some practice I can control it with very small, precise movements. I've read a little on throttle position sensors, which I'm somewhat familiar with, but also I'm finding posts about pots but those posts usually involve limp mode, which mine isn't going into (thankfully!). The boat has over 800 hours on it, I'm thinking something is worn out I'm just not sure where to start. I do have a multi-meter but I'm no pro at using it. Any ideas would be greatly appreciated, I believe the issue might be why my Tige set is so unstable.
My first thought was maybe a cylinder or 2 wasn't coming to life until 20% throttle but after some practice I can control it with very small, precise movements. I've read a little on throttle position sensors, which I'm somewhat familiar with, but also I'm finding posts about pots but those posts usually involve limp mode, which mine isn't going into (thankfully!). The boat has over 800 hours on it, I'm thinking something is worn out I'm just not sure where to start. I do have a multi-meter but I'm no pro at using it. Any ideas would be greatly appreciated, I believe the issue might be why my Tige set is so unstable.
Comment