Electrical Problems

[BlackoutATX]

So I can't quite make it out in your pic, and the charging system did change between Indmars sent palletized setup and Tige's final build (you will probably find just back in the harness a doubled back red wire that Indmar ran to the starter).

Guess you have a mini little bus bar with a threaded post that holds the MRBF fuse that's blowing. If that's the case the Alternator is sending close to 95A and the fuse is inderrated. Couldn't tell you how the 60a is blowing. Just know it's losing.

Yes I have a Blue Sea Fuse Block Terminal as seen below. I guess Tige adds these as a precaution. I think this was as simple as not having the correct 100A fuse. I have no idea why a 60A fuse was put there.

71dypDUSfdL._SL1500_.jpg

[KoolAid]

Should have been a 125 from what I recall. The 60 amp was used on the two channel amp. Seems to me like someone installed the wrong one.

[BlackoutATX]

Should have been a 125 from what I recall. The 60 amp was used on the two channel amp. Seems to me like someone installed the wrong one.

Thanks for confirming. I’ve ordered the 120. Someone def just put the wrong one in there.


Sent from my iPhone using Tapatalk