I have an '05 24v and I am getting ready to order a heater craft 3 vent heater. Does anyone have this heater and if so where did you mount the unit and vents? Any complaints or suggestions on where to mount it, meaning "if I had to do it over I would have put it here"? Thanks for the help!
-
-
I have it on my 22V. I rarely use it here in Louisiana. The unit is mounted under the glove box. The vents are mounted as follows: one under the drivers dash rear wall, the others are mounted in the fiberglass portions under the seats on passenger side and rear near motor box. -
In north east PA we need it, we don't see 70 degree water temps till July 4th usually then loose them not long after labor day, we need it badly! How did you run the heater hose from the glove box area to the drivers area? Did you go all the way around the back or is there another way that I am not considering? Do you have a picture by any chance as to how it is mounted? Just trying to get ideas.Comment
-
GO look in my gallery and there is a picture of my two amps and the bottom right corner of the picture is the heater unit. To run it to the drivers side I think it is run under the front seats in the bow then to the drivers feet area. I have a picture of my 12" sub and the heater vent is behind the sub.
We have 70 degree water temp here in early March. Today the high is 76 degrees and clear skies. If you need better pictures let me know and I will take some for you.Comment
-
Well, in the nicest way possible, you suck!Originally posted by shane
We have 70 degree water temp here in early March. Today the high is 76 degrees and clear skies. If you need better pictures let me know and I will take some for you.
I just checked the web cam for our cove we ride in and there is already ice over the area, think I need a heater?? I was doing well not thinking about riding till WB mag showed up at the house Tuesday, now I an jonesing something bad. Thanks for the pics, I think that is where I am gonna mount mine and run the hose for the driver around the front. Do you have any issues with it not warming the driver's feet as well being it is a long run from the core?
Comment
-
Not at all the couple of times I have used it , it does a good job. The wife likes the fact that the heater vent on her side has a pull out feature that allows for the vent to pulled out.Comment
-
Best advise is to mount the heater unit under the dash on the bulk head. 1 vent will blow directly down on the driver and use the other vent (pull-out) and mount that on the drivers side part of the walk through. This will look clean and the section of the tube will be hidden under the dash. Yes, this is for the 2 vent heater and the passenger can use the pull-out vent for themselves. This is where we mount at the factory. On the 3 vent heater, I would mount the 2 in the same locations and on the 3rd vent this will have to go completely around the bow section and mount the vent on the observers section. This is a pain to do with all of the UPH installed. I would recommend the 2 vent heater since this was not installed at the factory. If yu need any assistance please let me know.
AndrewComment
Comment