Drive Shaft

[wlfnvegas]

The carbon flange on my PSS seal final went. I ordered the new part and it came. The replacement instructions seem pretty straight forward. One poential issue is the lock nut on the flange (trans side). Anybody have a good way to remove this?

[lakebum]

back the nut off far enough that it protects the threads and start to install the shaft again untill it presses the shaft out

[wlfnvegas]

Thanks Lakebum. That worked like a charm. Now All I have to do is figure out how to plumb the new PSS Seal into the cooling system.

[boatwakes]

On the exhaust riser there should be an 1/8" plug near the gasket surface where it mates with the manifold, use that: pull the plug and plumb in a BRONZE 90* fitting and correct size adapters for the hose.