Taps

[samw]

I have been searching the forum for a problem like mine. I haven't found it so I will post my problem
I move the taps either up or down and I get no movement of my taps plate. I do hear a clicking under my dash. Which I have traced it to a little module under my dash which I think is for the taps. Does any one know how to bypass the the switch and module to see if it is my switch/module or the pump. I have hydraulic ramps (2). I have checked fluid and that is good.
I am a little concerned about my pump due to my drain plug falling out and half of my engine compartment was under water and so was my pump. After this happened I checked if for water and didn't find any.

Any help would be great.

Sam

[kko]

although you didnt get water in the fluid the pump motor go have gotten submerged and damaged it.i would pull taps pump out and check it.also if water got that deep you might want to pull the starter and lube it before rust forms on it and causes problems for you.

[SFielding]

Did you get a response or solution to your taps problem? My boat is having the same issues.

[samw]

Did you get a response or solution to your taps problem? My boat is having the same issues.

Sfielding
yeah my pump motor was going bad. I had to replace the whole unit. It was around $180.