Depth Gauge not Reading

[Hammertime]

His would be a triducer. If he doesn't see speed or water temp, it could be a connection issue. If he sees both speed and water temp, connection is good, signal is going to CAN and ECM which means the depth portion of the triducer is bad. Unfortunately it requires a new unit.

Where is this located, under the floor? How do I pull the floor up? I have carpet in my '08 22ve.

I am considering replacing my paddle wheel with the Nautic Laugic GPS unit. The paddle wheel doesn't seem to maintain as constant speed as I hoped. It would fluctuate 2 mph at times while surfing.

[chpthril]

Port side of the engine, usually about the engine bellhousing is, next to the trans.

Stock prop on a heavily ballast boat can cause speed holding issues.