Lots of issues to fix!

[gwalp]

2013 RZ2, had a leak at my driveshaft which I've now fixed, but not until after taking on a lot of water and almost sinking the boat last week (killed the motor and barely got the boat out of the water in time). Wanted to see if any of these were easy fixes before having to take the boat into the dealer.

Issues:
1. Luckily the motor started up again once I got the water out. however it makes a loud click sound now and doesn't seem to start as easily as before?
2. Bilge pump doesn't work anymore (part of the reason why I almost flooded the boat). Found the inline fuse and it seems fine. Anything else that could have shorted out from being under water?
3. Factory underwater lights no longer work. When I push the button on the touchscreen panel the button doesn't light up either.
4. Factory Bluetooth no longer works. The button on the touchscreen is grayed out now.
5. The "Gauges" button on the touchscreen no longer works.

Any help would be appreciated!

[chpthril]

1) have you checked the oil for water? will likely be a milkshake looking color if its been run or oil level over full if its set and separated. Sounds like you may have ingested water and bent a push rod.

2) Under water should not effect a submersible bilge pump. My guess is it was not working long before. It will have two fuses (or breaker for the helm supply) and 2 sources of battery POS and a single ground. One B+ connects battery direct and powers the automatic side of the bilge which allows it to come on when the water rises. The 2nd is through the manual switch on the helm. This is for manual bilge operation. Does the pump run when the switch is flipped? if not, likely a bad pump or no ground circuit.
3) Likely a fuse or breaker labeled as ACC but could be labeled as lights. Start there to see of it has battery voltage on both sides.
4) Did 2013 have OEM BT? I dont recall and if it did, cant remember what it was........the Medallion unit maybe? Good luck finding the unit.
5) Sounds like a screen issue there

[KoolAid]

4) Could be the bluetooth module. They are on 12.5's and above. Check for power and ground at the module on the single 8 pin connector. Purple wire is power and grey/black is ground. It will be towards the left of the stereo module under the dash.

5) Any other functions not working on the touch screen such as lights or is it just not going to the gauges screen?

chpthril covered everything else :-)

[Surf406]

I'm gonna go with the medallion as well