Does anybody know how Tige wires the Alpha Z arch for speakers? Are all 4 wire independently or ports and star boards pairs wired in series or parallel etc.
-
-
In 2014, I think Tige used a pair of 16ga 2-conductors, one for each side. These are split in parallel for the 2nd pair. IIRC, this parallel split was close to the tower fold, port side.
IMO, minimum for stock amp, but undersized for any upgrade in power.Mikes Liquid Audio: Knowledge Experience Customer Service you can trust-KICKER WetSounds ACME props FlyHigh Custom Ballast Clarion LiquidLumens LEDs Roswell Wave Deflector And More -
What gauge wire do recommend for a Syn4 powering a pair of Rev 8’s?Comment
-
12/2 to each podMikes Liquid Audio: Knowledge Experience Customer Service you can trust-KICKER WetSounds ACME props FlyHigh Custom Ballast Clarion LiquidLumens LEDs Roswell Wave Deflector And MoreComment
-
Thank you.Comment
-
My thoughts on running new wire on the Alpha Z, is to butt connect the new wire the speaker end of the old, and pull back through. Does that sound reasonable or any other suggestions?Comment
-
As long as the old wire is not taped or zip tied to other wires or something. However, a butt connector can create a lip that can catch somewhere. id overlap the wires about 6" and tape them together. Will be a smoother pull IMO.Mikes Liquid Audio: Knowledge Experience Customer Service you can trust-KICKER WetSounds ACME props FlyHigh Custom Ballast Clarion LiquidLumens LEDs Roswell Wave Deflector And MoreComment
Comment