Announcement

Collapse
No announcement yet.

HTX6 / Speaker issue

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    HTX6 / Speaker issue

    I have a wetsounds HTX6 and and have one of four in boat speakers not working. The speaker is fine, it works when I plug it into another location. It is the amp, an RCA (unlikely) or the speaker wire.

    Before I start tearing into the wiring, the amp LED is blue, then blinks red/purple 3 times.

    I cannot find what this sequence means. Does anyone know?

    #2
    Where is the suspect speaker getting its signal from? In other words, what chnl is it on and what mode is the amp set in/how many RCA to the amp?

    You can swap RCA to see if the problem moves or stays, and unplug speaker outputs and move them around.
    Mikes Liquid Audio: Knowledge Experience Customer Service you can trust-KICKER WetSounds ACME props FlyHigh Custom Ballast Clarion LiquidLumens LEDs Roswell Wave Deflector And More

    Comment


      #3
      Looked at the speaker outputs and found one of the wire pairs had pulled out of the quick disconnect plugs. I put the wire back in and screwed them down, but it seems the connection is less than completely secure. Will see if it holds...

      Comment

      Working...
      X