My brother just bought a 2011 Rz4 and the sub just can't keep up with the rev 10's and rev 8's on the tower. It is a factory installed Wet Sounds 10, assuming its free air. Has anybody replaced the sub, and is there room to build a box for a 12" sub in the same location. I looked in the compartment just forward of the driver and the heater core is installed there, couldn't see the back of the sub. I have an 06 24ve and have installed a sub in that compartment. Any help is appreciated before I tear into it! Thanks.
-
-
akdoc, the short answer is yes, I have put an xs 12 in a box in my 2010, and a XXXv2 in my 14 under the helm in boxes, you will have to move some stuff around but they fit well. -
I'm assuming there are 2 walls there, one in the front compartment that the heater core is mounted on, then another one that is just in front of the drivers seat?Comment
-
Yes, you will need to cut the wall out where the current sub is located and remove the divider that the heater is mounted to. I just mounted my heater to the top of the Sub box but others may have better ideasComment
-
I have a 2010 RZ2 and here is what I did! Two Free Air 10" 2ohm WS subs, wired in series and bridged on ch 5&6 on my Sinister6 amp. Thumps pretty good!
IMG_7715.jpgIMG_8227.jpg2010 Tige RZ2 "Fully Loaded" 650hrs
Surf Ballast & Enzo Bag - 1235 propComment
-
These things need room and power. I also have installed 2 10FA 2ohm at the helm. Behind the woofers I cut a hole 9" in diameter into the wall and in doing so opened up the factory box, the woofers now utilize the entire bow as 1 big box. Mine are run in a series and are bridged on ch 5 and 6 of a syn6 wetsounds amp. Also you'll need to do some fine tuning with the gain and frequency on the amp. For just 1 2ohm 10fa just use ch 5. For 1 4ohm 10fa bridge ch 5 and 6 I believe.
Sent from my SAMSUNG-SM-G930A using Tapatalk2015 Tigé R20Comment
-
2013 RZ2 with Convex VX, MLA Custom SacsComment
Comment