iphone direct to amps

[Guest]

My Clarion receiver died and while I am waiting on a new one (warranty!) I wonder if there is any way to connect an iphone directly to my wetsounds amp/amps. I have a SYN6 running the sub and internals and SYN4 on the towers. My Googles are not turning up anything that is helping. And I don' know how to get around the remote wire turning on the amp.

Anyone know of some low cost magic to perform so I have proper tunes on the boat tomorrow? I think I am SOL. As always thanks in advance to all you gurus out there.

[Greeko]

You could hook up one amp easily. You buy a male dual rca to headphone jack. You can get them at any local Best buy.

As for the remote wire... you have to run a jumper to power while you are running. Make sure you remove it afterwards or you will kill your battery!

[Guest]

ok cool. I have that cable for my old school garage stereo so I can connect the iphone. And that makes sense on the remote wire too. Thanks!

[Chads972150]

i use the rca's like that on my radio cooler but i have a switch in my jumper so that way im not always disconnecting it just flip the switch off

[chpthril]

To get both amps a signal, you can use a pair of Y cables but you may need a pair of F to F RCA adapters if you connected at the head-unit ends rather then the amps.