Hey guys, I need some advice on how I should have my settings. I'm running a SD2 to 4 Rev 10's. The speakers right now sound really loud and hi. I have them set to Full pass. What should I do?
Thanks in advance guys!
Thanks in advance guys!
-
-
Start by getting them off full-pass and set them to hi-pass. 4 10" HLCDs driven with 310W rms each, is going to be rip-your-face-off loud if you turn the volume up
The gain level needs to set through a proper procedure. Too high is not good. When set to hi-pass, you now need to adjust the cross-over point. No higher than 100Hz and no lower than 80Hz.Mikes Liquid Audio: Knowledge Experience Customer Service you can trust-KICKER WetSounds ACME props FlyHigh Custom Ballast Clarion LiquidLumens LEDs Roswell Wave Deflector And More -
So 90Hz is just right... Nursery rhyme momentOriginally posted by chpthril View PostStart by getting them off full-pass and set them to hi-pass. 4 10" HLCDs driven with 310W rms each, is going to be rip-your-face-off loud if you turn the volume up
The gain level needs to set through a proper procedure. Too high is not good. When set to hi-pass, you now need to adjust the cross-over point. No higher than 100Hz and no lower than 80Hz.
Comment
Comment