I'm planning to install an MW1 on my R20. Any suggestions for drilling the hole in the dash below the cruise control interface where the factory installs the MW1?
Will a hole saw cut a good hole in the plastic panel and material covering it or will it rip/tear the material covering the panel?
Also, I'm planning to replace a Clarion M109 with a M303. Does anyone know if the connector is the same on the M303? I'd like to start preparing for the new one while I wait for it to arrive if I need to change the connector.
IMG_1903.jpg
Will a hole saw cut a good hole in the plastic panel and material covering it or will it rip/tear the material covering the panel?
Also, I'm planning to replace a Clarion M109 with a M303. Does anyone know if the connector is the same on the M303? I'd like to start preparing for the new one while I wait for it to arrive if I need to change the connector.
IMG_1903.jpg
Comment