amp wall ideas for 2009 RZ2

[Duncan]

I need an amp wall on our 2009 RZ2 for Syn-2, Syn-4, and Syn-6 (and space for another amp in the future). I would greatly appreciate any suggestions or pics of other amp wall installs.

One of may favorite amp walls was Majestics -- so clean!

[brett22i]

This is what I just did in my 24Ve for the same problem. I was waiting on my new power wire and distribution blocks to arrive, but also wanted to get my basic speaker wire, amp layout and design in place, so pay zero attention to the exposed wires. I wanted to get out on the water as we had one 80 degree day and was pumped to launch for the first time this year.
I basically made the biggest panel that would fit. What you see is one piece and it barely made it, should have done two but it worked?
I cut and removed two rectangle sized pieces into the carpet that is glued to the inside wall of the hull, opposite of where the factory amp are mounted. I used Liquid Nail to secure two 2x4 blocks of wood and then mounted the large piece of wood for the amp rack to said glued blocks. I pre drilled holes in the rack for the power and speaker wiring to be run behind and hidden from sight, just waiting to get back in there and start running larger power and ground and straightening things up.
1111.jpg

[91Terminator]

Here's an idea from a Z3...

[bryce2320]

http://www.tigeowners.com/forum/show...s-thread/page2

Not a RZ2, so you'll probably have even more room. Just glue some blocks to the hull, then screw a board to the blocks if you need more space back there to run the wires, then screw your amp rack down to it. I too got ideas of Majestics install!!!!