Announcement

Collapse
No announcement yet.

BATTERY COMPARTMENT

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    BATTERY COMPARTMENT

    IM NOW ON THE OTHER SIDE OF THE BOAT.I HAVE THE PROSPORT 20,IT SAYS NOT TO MOUNT ON CARPET.DO I JUST USE NEX WOOD ON TEK DECK JUST LIKE YOU DO FOR AMPS.I HAVE A'99 DD WITHBOTH BATTERIES IN COMPARTMENT WITH BLUE SEAS ACR AND SWITCH.EVERYTHING IS OUT.WHERES THE BEST WAY TO PLACE TO PLACE IT ALL.IN JASONS 21I WAS THAT A SINGLE BATTERY IN THERE?

    #2
    In Jason's 21i, we had the main cranking and house battery, ACR and on-board charger all in the starboard mid-ship locker.

    The ACR will not need to be accessed, but being able to see the combined light is nice. Same with the charger. Other then having the AC cable where you can reach it, theres nothing else to with the charger but see the indicator lights. If you do locate it in that small locker with the batteries, I would suggest leaving the door open during charging. This vents heat and gases.
    Mikes Liquid Audio: Knowledge Experience Customer Service you can trust-KICKER WetSounds ACME props FlyHigh Custom Ballast Clarion LiquidLumens LEDs Roswell Wave Deflector And More

    Comment


      #3
      THANKS AGAIN.I CANT SAY IT ENOUGH HOW MUCH I APPRECIATE YOUR HELP.SHOULD I PUT SPACERS TO KEEP PROSPORT 20 OFF CARPET?FOR HEAT REASONS.THANKS AGAIN

      Comment


        #4
        Originally posted by ST.TIGE View Post
        THANKS AGAIN.I CANT SAY IT ENOUGH HOW MUCH I APPRECIATE YOUR HELP.SHOULD I PUT SPACERS TO KEEP PROSPORT 20 OFF CARPET?FOR HEAT REASONS.THANKS AGAIN
        Yes, the added air flow helps
        Mikes Liquid Audio: Knowledge Experience Customer Service you can trust-KICKER WetSounds ACME props FlyHigh Custom Ballast Clarion LiquidLumens LEDs Roswell Wave Deflector And More

        Comment


          #5
          MUCH APPRECIATED

          Comment


            #6
            WHAT SIZE WIRE DO YOU USUALLY RUN FROM THE ACR TO THE BATTERY?AND ALSO WHAT SIZE FUSE SHOULD I USE FOR THE CRANKING BATTERY WIRE?THANKS

            Comment


              #7
              4ga cables for the ACR to battery and 14ga for GND wire, with a 5A fuse.


              WHAT SIZE FUSE SHOULD I USE FOR THE CRANKING BATTERY WIRE
              What will the fuse be feeding?
              Mikes Liquid Audio: Knowledge Experience Customer Service you can trust-KICKER WetSounds ACME props FlyHigh Custom Ballast Clarion LiquidLumens LEDs Roswell Wave Deflector And More

              Comment


                #8
                EVERYTHING EXCEPT NEW STEREO SYSTEM.FUSE WOULD BE FOR THE ORIGINAL +/- FROM BATTERY TO MOTOR.IT CALLS FOR A FUSE BETWEEN TERMINALS A&B OF ACR TO BATTERIES.I HAVE THE KICKER 100 AMP FUSE FOR THE STEREO AND ALSO AN EXTRA TSUNAMI 100 AMP CICUIT BREAKER THAT I COULD USE.THANKS AGAIN.

                Comment


                  #9
                  You do not need to fuse the cables going to the ACR. You will not need any circuit protection between the cranking battery and starter. The helm BUSS should already have a breaker.
                  Mikes Liquid Audio: Knowledge Experience Customer Service you can trust-KICKER WetSounds ACME props FlyHigh Custom Ballast Clarion LiquidLumens LEDs Roswell Wave Deflector And More

                  Comment


                    #10
                    THANKS AGAIN.DO YOU SELL CLEAN AIR KITS.I WANT TO START WAKE SURFING.WHAT IS A GOOD STARTER BALLAST SET UP FOR MY '99 21i?I JUST WANT TO ORDER EVERYTHING FROM YOU.WOULD YOU BE INTERESTED IN HELPING ME WITH THAT ALSO?THANKS AGAIN.

                    Comment


                      #11
                      PM sent about ballast.
                      Mikes Liquid Audio: Knowledge Experience Customer Service you can trust-KICKER WetSounds ACME props FlyHigh Custom Ballast Clarion LiquidLumens LEDs Roswell Wave Deflector And More

                      Comment

                      Working...
                      X