Fun With LEDs

[topaz surfer]

Yes. There are a couple of large dia pucks that fit those clarion tweeter holes.

Do you stock them and what are the colors and prices if you do?

[NICKYPOO]

That looks killer Mike. Nice work.

[lancehon]

that is way cool!!!!!!! nice work Mike

[chpthril]

Do you stock them and what are the colors and prices if you do?

I do not have any in stock at the moment, but can usually have them is a couple days.

They come in Blue, Red and White and the bezel is white and chrome. Requires a 2" mounting hole and the OD is 2.75". 4 LEDs and the lens is frosted.

$20.00 ea.

[topaz surfer]

I do not have any in stock at the moment, but can usually have them is a couple days.

They come in Blue, Red and White and the bezel is white and chrome. Requires a 2" mounting hole and the OD is 2.75". 4 LEDs and the lens is frosted.

$20.00 ea.

Thanks mike I might get some of those from you. I just need to decide if I want to go that route or go for the speaker grill leds. Im assuming I could tie them into my existing courtesy lights?

[chpthril]

Thanks mike I might get some of those from you. I just need to decide if I want to go that route or go for the speaker grill leds. Im assuming I could tie them into my existing courtesy lights?

You sure can!

[chpthril]

2012 Malibu 23 LSV Phase-1

Nothing too exciting, I just thought the green came out killer

Interior:
8 6.5" in-boats with rings
1 12" sub with a ring and puck in the grill
16 cup holders with rings and a puck in the center
rear "Wakesetter" emblem back-lite with an acrylic block
strip in the drivers storage pocket
Side "Wakesetter" red led strip replaced with green and pulled off the courtesy circuit and placed on the green led circuit

Exterior:
two forward vent and two aft vents

Under water:
two Shadow Caster SC-10's in green

The underwater lights are run through the Maliview, the exterior LEDs have a dedicated switch as does the interior.

Phase-2 will be 2 pair of Rev-10's on an SD-2, both with green LED rings.

[dingleberry]

Sweet!

[chpthril]

Thanks everyone, I hope you'll enjoy the pics. Ive got a Chap coming in Sunday that's getting all RGB's that will be on a controller that interfaces with the music.

2 Sea Blaze-3 in white
2 Rev-10 light rings
8 XS-650 with rings and pucks behind the tweeters
3 cupholders with rings and pucks
and then some miscellaneous RGB strips here and there.

[Timmy!]

Wow! That green is BRIGHT! Nice work!

[skippabcool]

The aliens are coming

[Timmy!]

The aliens are coming

I have those same green LED's in my Alienware PC...

[chpthril]

More Fun With LEDs: Scientific Test!

Ok, not really anything scientific, just having fun

My son is kicking around the idea of doing some LEDs on his snowboard for this coming season. He wanted to see how long some LEDs would last on a 9V battery. This would be small and easy to wire to the side of his boots. So i told him to just take a roll and and wire them to a battery and see.

One brand new dollar store 9V
one 16ft 300 LED single color strip of LED

We hot-glued the wires to the battery and wire-tied the battery to the spool. he took it home with him so he could keep an eye on it and note when it died.

Well, this pic was taken exactly 24hrs later! It was noticeably dimmer, but still glowing It finally died at 60hrs.

Amp draw and this 16ft 300 LED roll is 1.4 amps. The amp draw on a 16ft 300 RGB roll with all 3 colors lite was 4.6A.

[Moki]

Looks sweet! Strong work my friend!

[ST.TIGE]

can I wire them in to the speaker?if not,what siz wire should I use?thanks for everything!