Kicker amp wiring ?

[Dave K]

My Amp arrived today and next step is to decide on speakers. Seems both of these choices are good, but I was wanting to check with you guys if this is the correct way to wire up speakers?

Thanks for the help

[Dave K]

[philwsailz]

Looks good from here!


Assuming the PRO60's do not have any impedance dips that will cause a parallel load to dip below 2-ohms, that will work fine.

Also, many people will see the Kicker setup and say the three cans for the Kicker setup will deliver a lower than 2-ohm load, but the crossover design prevents that. The KM6500.2's mid and horn wired in parallel show a 4-ohm load, and when you add the extra KM6500 mids, you get a 2-ohm load.

Good luck!


Phil
Kicker