How to wire my tower?
I'm trying to figure out the best way to wire my tower. I have already started to route the wire from the top but have hit a couple problems. I was going to try to put both wires towards the passenger side of the boat but I can't get the drivers side to go over that way... it gets stopped in the top somewhere. It's very difficult to explain. I will probably just come down that tower on both sides...but what do I do when I get to the base of the tower. I have a hole about 3 inches above where the boat connects to the tower...so I imagine I have to put a hole in the fiber glass? Then but some tubing over the speaker wire like I will at the top of the tower where the wire will be exposed...I think pictures will help best.. from me and from others who have done this. I know the tower I have is a 2001 Metcraft I believe..or that's what I was told.. Here is a Pic of the boat from the back..maybe you can tell me what tower it is. I'm going to take some more pictures soon.
-
-
I'm fitna wire my tower and I'll post pictures, I don't have a metcraft tower but you'll get idea on what you need to doEveryone is entitled to their own opinion. It's just that yours is stupid. -
Personally, I like these.....
http://www.google.com/products/catal...CCkQ8gIwBzgA#p
Clean, easy, cheap, and plentiful.Other than that, Mrs. Lincoln, how was the play?Comment
-
Thanks.. but more help is needed...
Thanks man...I'm going to jump into the project on tuesday and wednesday. I gotta get out on the water the Saturday and I'd like to have my system ready to go if I can! Any recommendations on installing the amps? I have two amps... The Kicker 700.5zx and the 450.2zx.. The mounting board underneath the storage are is not big enough unless I put a bigger piece of wood there to mount it. I'm thinking I will do that and then just basically carpet the plywood I use and mount it on the area where the amps usually go.. if that makes any sense. I know I'm not the first guy to mount two amps so any advice on that two. The only things i have done thus far is the wiring of the amps. Most the boat is already wired for everything else besides the tower speakers.. makes my job a lot easier... I just want to do the job right...Originally posted by Fuh Sho View PostComment
-
-
It's the female half of the connector, it would mount through the deck and the male half would be on the tower side.Originally posted by h2osk8er00 View PostMikes Liquid Audio: Knowledge Experience Customer Service you can trust-KICKER WetSounds ACME props FlyHigh Custom Ballast Clarion LiquidLumens LEDs Roswell Wave Deflector And MoreComment
-
I found a great website that has all of the connectors, wires, etc that help make a tower install that much easier...check it out...http://www.audiopile.net/product_page.shtmlComment
Comment