Need Some Wet Sounds Advice For New 22ve

[chpthril]

Check out the Tige gallery on Wet Sounds http://www.wetsounds.com/pages/galle...tige/tige.html and you will see a couple of installs with the sub in that location.

The Syn2 will do 700 watts RMS x 1 with the XS-12D2 wired in series (= 4ohm's) and you will not be disappointed with this setup.

You should not have any trouble building a .9 box that will fit through the front opening, when assembled, and then use the sub's mounting screws (will need longer then whats supplied) to secure the box to the back of the wall.

David cought my typo, thanks

The XS-12D2 should be wired in series, which = 4ohm. This is the correct configuration for bridging on the Syn2.

[Bryce]

Thanks for the correction. I don't even know enough about stereos to be ignorant, and for that reason I will pay a professional to do the install for me!!!

[chpthril]

No problem. It would have a huge impact on the output of the system. The wrong sub, or correct sub wired the wrong way would result in either too low an impedance at the amp, which could cause damage, or too high an impedance and end up with poor output.