If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
was just talking to a salesman from a boat dealer around here (getting recommendations for minor vinyl repairs), and he mentioned that Tige had just contacted them about possibly carrying the line
but I just can't see it happening - they already carry MC, Axis, Supra, and Moomba, along with Cobalt and some other non-wake brands
That would be great! Hopefully they make something happen.
Hopefully mike will chime in about needing another 0 gauge run to distro block
What are your amps again and are they all being fed by the distribution blocks? Batteries are in the same locker right?
Mikes Liquid Audio: Knowledge Experience Customer Service you can trust-KICKER WetSounds ACME props FlyHigh Custom Ballast Clarion LiquidLumens LEDs Roswell Wave Deflector And More
What are your amps again and are they all being fed by the distribution blocks? Batteries are in the same locker right?
Batteries are in the rear ski locker. 3 Syns 4's, 1 JL 1000/1 slash. I have 1 0 gauge feeding the distro block as is, but the distro has a spot for another one if it needs it?
Batteries are in the rear ski locker. 3 Syns 4's, 1 JL 1000/1 slash. I have 1 0 gauge feeding the distro block as is, but the distro has a spot for another one if it needs it?
True it does, but the ground side share the total load equally. So if the potential load calls for a larger pos or a 2nd pos, then it would automatically need to do the same on the GND. Keep in mind that on a car, the whole chassis is the ground plane, so the grounds runs are typically short and do not run all the way back to the battery.
Mikes Liquid Audio: Knowledge Experience Customer Service you can trust-KICKER WetSounds ACME props FlyHigh Custom Ballast Clarion LiquidLumens LEDs Roswell Wave Deflector And More
Comment