Im lost without the PW thread!!!!

[skippabcool]

Hey guys- currently installing my fae to those who've installed it. The measurement between my prop and fae is greater than the 1.5-2.5". The trailer is totally level. I've adjusted everything and can only gain .5" but I loose the vertical ....thoughts/ideas?

Thx- ray

Any pics?

[skippabcool]

How much greater?

[chpthril]

Hey guys- currently installing my fae to those who've installed it. The measurement between my prop and fae is greater than the 1.5-2.5". The trailer is totally level. I've adjusted everything and can only gain .5" but I loose the vertical ....thoughts/ideas?

Thx- ray

Ive installed 3. Im not sure I fallow the dimensions regarding the prop and FAE. Do you mean TAPS plate? If so, as long as there's space for the plate to travel its full swing.

[halfwatt]

The distance from ground to prop is 15"
The distance from ground to fae pipe is 19"
According to the install instructions says the difference should be 1.5-2.5"
My difference is 4"

The taps plate is completely clear at this point.

[halfwatt]

- sorry the pic isn't uploading

[skippabcool]

The distance from ground to prop is 15"
The distance from ground to fae pipe is 19"
According to the install instructions says the difference should be 1.5-2.5"
My difference is 4"

The taps plate is completely clear at this point.

Just to double check you are measuring to the center of the prop, correct?

[chpthril]

The distance from ground to prop is 15"
The distance from ground to fae pipe is 19"
According to the install instructions says the difference should be 1.5-2.5"
My difference is 4"

The taps plate is completely clear at this point.

Wish I could be of more assistance, those dimensions seem to be new since the last one I did.

[skippabcool]

They were that way when I did mine a year ago.

[skippabcool]

Mike, I need to give you a call. I think I am going to get the wire, breaker, and distribution blocks and see if that will get rid of my pop. I was waiting to install my Zone Controller too.

[skippabcool]

Does the Zone controller go before or after the amps?

[halfwatt]

Just to double check you are measuring to the center of the prop, correct?

Yes. Center of the prop (537)

[skippabcool]

Are doing the quick connects?

[chpthril]

Mike, I need to give you a call. I think I am going to get the wire, breaker, and distribution blocks and see if that will get rid of my pop. I was waiting to install my Zone Controller too.

Call any time, we'll get you fixed up.

[chpthril]

Does the Zone controller go before or after the amps?

Before: Single RCA set form the head-unit, is then split off into each zone by the ZLD.

[skippabcool]

Call any time, we'll get you fixed up.

I'll give you a call in the morning.