Im lost without the PW thread!!!!

[majestic]

I double checked the drain on the one that seemed slow. I fastened the hose down so it was level. I thought it was faster until I tried the other side. I wanted to check the cartridge, but couldn't get the top off. How do you take the top off of the Rule 405FC?

If I remember there is a tab you have to push while you twist.

[thtrog]

If I remember there is a tab you have to push while you twist.

I was going to say pull and twist I really don't know

[glassmaker]

The PMT factory is in TN, but the sales rep is in Orlando.

I will be in Knoxville on business at the end of the week...I will see if I can find time to stop by and see if they will sell direct...

[skippabcool]

If I remember there is a tab you have to push while you twist.

I tried that but it didn't budge. One of those things I haven't done so I am being careful so I didn't break it.

[thtrog]

I will be in Knoxville on business at the end of the week...I will see if I can find time to stop by and see if they will sell direct...

Welcome glassmaker!

I'm not really interested in organizing a group buy, but will ask if they would offer a discount code if there is enough interest. They do sell direct on the website, but also sell to several boat mfgs as factory options.

[majestic]

I tried that but it didn't budge. One of those things I haven't done so I am being careful so I didn't break it.

Here's a video and he pops the motor off.

http://www.wakemakers.com/rule-aerat...pump-1100.html

[mls6722]

You probably only needed half a sheet as well huh ?

Lance, 1/2 a sheet would not have been enough, but with what I have remaining, you might be able to do a 1/2. I have enough to make 1 panel and you are welcome to it.

[skippabcool]

Here's a video and he pops the motor off.

http://www.wakemakers.com/rule-aerat...pump-1100.html

Thanks. I was just looking at that. I will have to try again.

[thtrog]

Thanks. I was just looking at that. I will have to try again.

try a hammer and crow bar

[thtrog]

Oops, it's past my bedtime. Nite hoes!

[skippabcool]

Nite ET

[mls6722]

nite ET - I hope Benji's back is better quickly.

[mls6722]

quiet night - I could do a couple more things, but mostly I am now waiting for parts to arrive. I think I can modify the old compartment back panel to make a good cover in the new location.

[lancehon]

Lance, 1/2 a sheet would not have been enough, but with what I have remaining, you might be able to do a 1/2. I have enough to make 1 panel and you are welcome to it.

Thanks for the offer! Are you going to carpet them or just leave the white?

[lancehon]

Good night ET