If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Spring is going to be busy project-wise. Gotta get the new dock built and installed, gotta finish up this sailboat in case we get enough rain to get the lake back full... Gotta start thinking about deck work next door at my sister's and brother-in-law's place. They have a bunch of OLD rotten deckwork that needs removed to bare earth and rebult...
It's not an optical illusion.
It just looks like one.....
At this point, in hindsight I should have been adamant with my painter buddy and made him paint the decks prior to my application of non-skid... the little bit of white gel left on the decks and cabin roof could have been easily shot and cleared prior to addig this non-skid.
Where I am now, I still have to get busy with a bunch of very fine wetsanding and polishing to get the white, (actually it is cream-olor under all that oxidation) back smooth and shiny. It is going to be a real bear to get it all shiny and smooth....
It's not an optical illusion.
It just looks like one.....
Post and go, I have the day off! But lots of work to do around the house still before I go to OK. Going to pull the boat out of the garage and mark the Bimini for the surf pockets. I think WAboating found the same guy I did to add the surf pockets on top.
2009 RZ2, PCM 343, MLA Surf Ballast, Premium Sound.
2013 Toyota Sequoia 4WD W/Timbren SES
Post and go, I have the day off! But lots of work to do around the house still before I go to OK. Going to pull the boat out of the garage and mark the Bimini for the surf pockets. I think WAboating found the same guy I did to add the surf pockets on top.
When you coming through?
"Failing to prepare is preparing to fail" John Wooden- Rest in Peace
Comment