Im lost without the PW thread!!!!

[skippabcool]

Morning all

[robert theisen]

Working for a living post.

[Ewok]

Morning hoes.

[dingleberry]

I hate Mondays.

[robert theisen]

I hate Mondays.

Go on strike!

[Ewok]

Off to work

[lancehon]

Head hurts

[philwsailz]

Monday...


All darned day...

T- 4 and counting til the weekend...

[Timmy!]

Hey Phil - how do I hook up a ZX200.2 using the low level inputs? It look like there is a special plug that I need but I don't have it and don't see it available for purchase on the kicker website.

[philwsailz]

Hey Phil - how do I hook up a ZX200.2 using the low level inputs? It look like there is a special plug that I need but I don't have it and don't see it available for purchase on the kicker website.

No special plug... Use an RCA cable from back of radio to RCA amp inputs...

If that doesn't make sense, show me a pic so I can see what you are seeing...

[Timmy!]

Sorry Phil, I meant high level...i.e. - speaker wires from a factory radio.

[Iwndr]

No special plug... Use an RCA cable from back of radio to RCA amp inputs...

If that doesn't make sense, show me a pic so I can see what you are seeing...

we are starting to use a skype type program for our field techs to troubleshoot. it has been working well for our PLC racks and wiring issues. We are using iPads to transmit the data. We helped a op troubleshoot out in Bahrain last month

[dingleberry]

post for plugs

[philwsailz]

Sorry Phil, I meant high level...i.e. - speaker wires from a factory radio.

Ah... Several ways

Get the Kicker ZISL, (available lots of places) and simply connect your radio's speaker wire.

Or, go to radio shack and get two male RCA ends. The wires without the black stripe connect to the center pin, and the wires with the black stripe connect to the outer ring. YOu will do this for both the lef tand right inputs and you will usiually use the white and white/stripe wire and also the grey and grey/stripe wire.

Or... Take a set of RCA cables and cut the ends off. When you cut each end off you will find a small inner wire and an outer wire usually wrapped around the inner wire in a spiral. Making sure the inner and outer wires do not touch during the process, conect the outer wier to the wire with eth black stripe and the inner wire to the non-striped wire. Do this for both left and right, usually white and gray.


Make sense?

[Timmy!]

Didn't realize I could do that with the RCA's. Thanks! I have a set that I can cut up. I think I am going to buy a Comp 10" and throw it in my truck with the ZX200 that it is just laying around doing nothing. Cheap bass. LOL.