If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Me either but I am going to make some adjustment's this winter. I am not adding crossover's as I dont see the point of all the extra hose, fittings and pumps to pick up a couple of minutes
New ballast idea. Cut a 6" hole in the transom on each side. Each hole will have a gate, either manual or power. Waterproof and seal off the lockers as far up as you would like. No need for sacs. Open gate water enters and in seconds ballast is full. To empty have a smaller hole and gate that opens to the keel and use the bilge pump to empty.
New ballast idea. Cut a 6" hole in the transom on each side. Each hole will have a gate, either manual or power. Waterproof and seal off the lockers as far up as you would like. No need for sacs. Open gate water enters and in seconds ballast is full. To empty have a smaller hole and gate that opens to the keel and use the bilge pump to empty.
** Note to self, test bilge pump first
Give us the performance results after you run your sea trials.
Comment