Im lost without the PW thread!!!!

[Iwndr]

Nice Mike, When you coming out to your Mountain Division?

[skippabcool]

Dr, is close to 13,000.

Any big announcements at 13,000?

[chpthril]

Chp, do you know of anyone that has left the old style transom light in and gone with two new LEDs?

Yur looking at it! Thats Jack Rose's 06 22ve with the OEM 3" thru-hull transom light. Left it right there and just clipped it from the harness and wired the pair of Shadow Caster LEDs to the factory harness.

Doesn't look as clean out of the water as one that didnt have the OEM light, bit it would be a heck of a job to make that lamp go away.

[chpthril]

Nice Mike, When you coming out to your Mountain Division?

If I ever left NC, WY or UT would be on the short list for sure.

[skippabcool]

Yur looking at it! Thats Jack Rose's 06 22ve with the OEM 3" thru-hull transom light. Left it right there and just clipped it from the harness and wired the pair of Shadow Caster LEDs to the factory harness.

Doesn't look as clean out of the water as one that didnt have the OEM light, bit it would be a heck of a job to make that lamp go away.

Do you have a pic of it out of the water? Since you snipped the old one, is there a separate switch for the news ones or do they run off the factory switch? Which factory switch should the transom light come on with?

[skippabcool]

If I ever left NC, WY or UT would be on the short list for sure.

No CO, it is warmer here than UT. Unless you go to southern UT.

[Iwndr]

Sauced it up after I tightend up the Bow Eye

[skippabcool]

Sauced it up after I tightend up the Bow Eye

You don't have snap in carpet in the bow?

[chpthril]

Nice Mike, When you coming out to your Mountain Division?

Saw that you called, sorry i didnt pick up.

I was trying to chisel out the dining room door frame so i could get the new frig into the kitchen.....missed it by that much

[Iwndr]

Notice I left the hose in its sheath

[Fiveflat]

Is pumping the board, weight in front then back, or side to side like on the old skate boards?

It's a little of both actually. Not a lot of "back". But pump the front and it'll sorta slide away from the wave like that old skateboard trick. You need a little weight on your toes when you pump.

I'll find video for you. Hard to explain.

On iPhone towing brothers MC with my bad alt.

[skippabcool]

holsetered

[Iwndr]

Saw that you called, sorry i didnt pick up.

I was trying to chisel out the dining room door frame so i could get the new frig into the kitchen.....missed it by that much

NP I figured you were busy I'll call during business hrs

[skippabcool]

It's a little of both actually. Not a lot of "back". But pump the front and it'll sorta slide away from the wave like that old skateboard trick. You need a little weight on your toes when you pump.

I'll find video for you. Hard to explain.

On iPhone towing brothers MC with my bad alt.

Thanks.

Good luck on the boat.

[chpthril]

Do you have a pic of it out of the water? Since you snipped the old one, is there a separate switch for the news ones or do they run off the factory switch? Which factory switch should the transom light come on with?

I will get a pic before he comes to pick it up. used the orignal ACC switch for the new Shadow Casters that was powering the old transom light.