Im lost without the PW thread!!!!

[skippabcool]

Home from an awesome day

We were at the lake at 8:30 and left at 5:00. Almost didn't go because the weather was looking crappy and didn't want to drive for 2 hours to turn around and head home. Beautiful , clear, smooth water. A nice 60 degree water temp and 66 air. I left my wakeboard at home so I would not be tempted to go. It is a good think because I was trying to figure if I could fit into some of the smaller bindings. We then filled up the sac and gave surfing a try. I didn't fill the sac all the way not know anything and being cautious. To me it was a good wake. I was able to get right up, yes I was not going to just drive all day I had to get in the water. I couldn't get the wave to push me for long, operator error, of the surfboard. My buddy tried it and didn't want to stop. His wife gave it a try as well as some of the kids. We then emptyied the sac and filled up the tube. The thing is huge. I pulled from the pylon All the kids had a blast in it. They didn't want to stop.

Two worst parts of the day paying for the fuel truck and boat and the long drive.

[skippabcool]

Chp, the sac, pump and prop rock

Thanks for hooking me up

[thtrog]

Sounds like a fun day Skippa!

[surfsup]

Chp, the sac, pump and prop rock

Thanks for hooking me up

Glad to hear yur having fun with the setup

[thtrog]

I'm turning in hoes, have a good night.

[skippabcool]

I need to check with Larry to see how I can reduce the spray from the FAE.

Also, before the 1235 and FAE I was turning 5000 rpms and 37-38 mph WOT. Now it is 4700 - 4800 rpms and 34 mph. Is this the prop, FAE, or a combo?

I wondered how close my mph were and checked them with an app on my evo. It looks that it might be 2 mph slow. I had check my evo with my gps and car speedo before.

Does anyone know if there is a way to adjust the speed or is that a flash of some sort at the dealer?

[skippabcool]

I'm turning in hoes, have a good night.

Nite ET

[skippabcool]

Dr, did anybody get in today?

[skippabcool]

Changing computers post

[surfsup]

I need to check with Larry to see how I can reduce the spray from the FAE.

Also, before the 1235 and FAE I was turning 5000 rpms and 37-38 mph WOT. Now it is 4700 - 4800 rpms and 34 mph. Is this the prop, FAE, or a combo?

I wondered how close my mph were and checked them with an app on my evo. It looks that it might be 2 mph slow. I had check my evo with my gps and car speedo before.

Does anyone know if there is a way to adjust the speed or is that a flash of some sort at the dealer?

Try moving the down pipe either closer the TAPS plate and then away from the TAPS plate. I used a paint pen to make the starting point on the pipe and the connecting hose. This way i could move it in or out to see what works the best and I new where I started.

[majestic]

I need to check with Larry to see how I can reduce the spray from the FAE.

Also, before the 1235 and FAE I was turning 5000 rpms and 37-38 mph WOT. Now it is 4700 - 4800 rpms and 34 mph. Is this the prop, FAE, or a combo?

I wondered how close my mph were and checked them with an app on my evo. It looks that it might be 2 mph slow. I had check my evo with my gps and car speedo before.

Does anyone know if there is a way to adjust the speed or is that a flash of some sort at the dealer?

You could try adjusting the FAE, I don't have a spray issue. My boat turns 4000 RPM's at 30 mph and I have the 1235. Be careful my MP manual says max RPM's is 4600.

[majestic]

Try moving the down pipe either closer the TAPS plate and then away from the TAPS plate. I used a paint pen to make the starting point on the pipe and the connecting hose. This way i could move it in or out to see what works the best and I new where I started.

My FAE is about 1/2 inch off the taps plate when the taps is at 8.

[Iwndr]

Dr, did anybody get in today?

No I wanted to but held off,

[Iwndr]

I can wait another week

[skippabcool]

My FAE is about 1/2 inch off the taps plate when the taps is at 8.

Mine might be an inch away. I will have to double check. When TAPS is on 0 is when it sprays when I move ti up it goes away.