Im lost without the PW thread!!!!

[chpthril]

Wheres the best place to get the speaker sox. Should I order them right from wetsounds?

If you want the Wet Sounds logo.

[chpthril]

Got a broken wrist post

no chit! wut happend?

[Nobody]

If you want the Wet Sounds logo.

Chap, what's your comparison evaluation between Pro60's and Pro80's? (given the same wattage)

[Iwndr]

Hopefully Eddie is taking lots of pic's of his unwrapped pylon transport device

[Nobody]

Water Temperatures for Gulf of Mexico - March 28th , 2011

Notice the "78" degrees in the middle lower gulf region...this is caused by a massive oil slick beneath the surface. Crude oil retains heat.

[chpthril]

Chap, what's your comparison evaluation between Pro60's and Pro80's? (given the same wattage)

Ok, lets say each pair is powered by a Syn2, so thats 200W rms to each speaker.

Both will be loud and clear and project out to a rider. At riding distance, not a huge difference, but maybe a bit of an edge to the 80's as they have a slightly larger horn.

Near in is where the difference can be heard. The 80 will project more mid-bass, so they can be x-overed a bit lower then the 60's. This gives you a more broad spectrum of sound as you are able to fill in those frequencies from, lets say 120Hz (for the 60's) down to 80Hz (for the 80's). This reduces some of the "brightness" or harsh tone that is inherent with HLCDs. Now, keep in mind, the lower the speaker is x-overed, the more conservative one needs to be with the gain and volume. Thats the trade off.

[ImaPigDog]

I never got the pro 80's because I thought they would be 2 big, I'm a tall guy and didnt want to be bumping my noggin. Are they that much better?

B-

I went from 1 pair of pro60s to a pair of pro80s and mb-8s. Although there is more head bumping, the sound is a lot better. The 80s project much better (further) and have much better mid-bass.

[Nobody]

Ok, lets say each pair is powered by a Syn2, so thats 200W rms to each speaker.

Both will be loud and clear and project out to a rider. At riding distance, not a huge difference, but maybe a bit of an edge to the 80's as they have a slightly larger horn.

Near in is where the difference can be heard. The 80 will project more mid-bass, so they can be x-overed a bit lower then the 60's. This gives you a more broad spectrum of sound as you are able to fill in those frequencies from, lets say 120Hz (for the 60's) down to 80Hz (for the 80's). This reduces some of the "brightness" or harsh tone that is inherent with HLCDs. Now, keep in mind, the lower the speaker is x-overed, the more conservative one needs to be with the gain and volume. Thats the trade off.

You use the term, "x-overed". I'm unaware of what this means?

[robert theisen]

Looks like you guys have been busy.Igot to get some dinner.later

[chpthril]

You use the term, "x-overed". I'm unaware of what this means?

X-over = crossed over. its the frequency range in Hz that you set for the speaker. In the hi-pass mode, you are setting the "floor" for the frequencies. Nothing below that setting gets sent to the speaker. In low-pass, you are setting the "ceiling" and nothing above that gets sent to the sub.

[Nobody]

X-over = crossed over. its the frequency range in Hz that you set for the speaker. In the hi-pass mode, you are setting the "floor" for the frequencies. Nothing below that setting gets sent to the speaker. In low-pass, you are setting the "ceiling" and nothing above that gets sent to the sub.

Thanks!!!!

I didn't know that.

[Nobody]

top of page post for certified, accredited, genuine Dbags.

[robert theisen]

last post

[Nobody]

This post is certified and Grade D

[robert theisen]

DBAG POST AUTHORIZED.