Im lost without the PW thread!!!!

[skippabcool]

Off to a good start

[skippabcool]

One time, I was pissed because I couldn't get SpeedSet to work. I was all upset and cursing.

After I got home, I realized that I had never turned it on with the toggle switch.

Mine doesn't show the digital speed if the toggle is not on. It might be that I don't have it set correctly or don't know how

Where I got mine they did not know anything about the boat.

[skippabcool]

my boys just started...not sure if they will take it seriously yet

I don't recall if they are twins? From the one picture if they are not twins, Riley is younger?

[dingleberry]

I don't recall if they are twins? From the one picture if they are not twins, Riley is younger?

They are twins. Riley is younger - by one minute.

[skippabcool]

They are twins. Riley is younger - by one minute.

I did good at guessing. Do they feed off of each other?

[skippabcool]

My 6 year old twins come up with things that my older two never could alone.

[skippabcool]

I think that it is getting to that time.

[skippabcool]

To call it a night.

[skippabcool]

I have been trying to get some center caps for my trailer wheels and was finally sent some that looked right. They do not fit because of the trailer buddy for the axles. I called to ask them about it and I was told that they are correct. I was told to just cut a hole it the center of the cap. I thought that was kind of odd? What are you guys thoughts? The caps have the brand written in the center so it will be partially cut off.

[skippabcool]

One more question.

I got new Tige side marker lights, they are sealed and one did not work. From the factory they are riveted in, the old ones were screwed in, shorter than what the new lights will need. I have been searching for the correct rivet, I need a bigger grip then what is in the local stores. Should I keep looking or just find some screws?

[skippabcool]

Morning is going to come quick.

[dingleberry]

I did good at guessing. Do they feed off of each other?

Oh yeah, all the time.

I have been trying to get some center caps for my trailer wheels and was finally sent some that looked right. They do not fit because of the trailer buddy for the axles. I called to ask them about it and I was told that they are correct. I was told to just cut a hole it the center of the cap. I thought that was kind of odd? What are you guys thoughts? The caps have the brand written in the center so it will be partially cut off.

I don't know. Mine are a pressurized hybrid oil system, not grease bearing buddies.

One more question.

I got new Tige side marker lights, they are sealed and one did not work. From the factory they are riveted in, the old ones were screwed in, shorter than what the new lights will need. I have been searching for the correct rivet, I need a bigger grip then what is in the local stores. Should I keep looking or just find some screws?

Finding a screw is (almost) always good.

[skippabcool]

Oh yeah, Finding a screw is (almost) always good.

LOL

[skippabcool]

Thought it was time to call it a night but still getting scout emails and had to play nurse. My oldest boy had ear aches and had to go to the Dr. We couldn't get into to see Dr TO They said that both of his eardrums are about to burst

At least I haven't got a call for work, yet.

[skippabcool]

I don't know. Mine are a pressurized hybrid oil system, not grease bearing buddies.

Here is a picture very similar if not the same to the caps that I am talking about cutting.