If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Added a circuit breaker and a new trunk line to the amps with a distro block. I also have a Kicker Zone controller that I have been waiting to install.
Wires all ran. Volume knobs are installed. I am rewiring my stereo switch to the distro block, I need to finish this and install the module for the zone controller.
Ah - I remembered the zone controller, but wasn't sure about the rest.
Timmy, Chpthril, Phil, or anyone else - When doing the Kicker zone controller do you have to have a special cable since both sides of the controller have female rca connectors?
I don't remember what I did there, I think I had a short cable to run between the head unit and the ZXMRLC.
Added a circuit breaker and a new trunk line to the amps with a distro block. I also have a Kicker Zone controller that I have been waiting to install.
Wires all ran. Volume knobs are installed. I am rewiring my stereo switch to the distro block, I need to finish this and install the module for the zone controller.
Were your power/ground wires all wrapped in electrical tape?
Comment