Im lost without the PW thread!!!!

[skippabcool]

Congrats to lil Ms Dr

[thtrog]

mid 80s here today, now its raining and 50s next 2 days

[skippabcool]

Just got back from the lake

[thtrog]

Shaved the beaver today, but left a gotee... Mrs Hyphen isn't sure about it. HAHA!

[thtrog]

Just got back from the lake

You lucky dog..It must have went well for you

[skippabcool]

You lucky dog..It must have went well for you

Pretty good it started out bad. Now I have another problem to fix. Not an easy one either.

[Wakeman22]

Skippa how did the water test go?

[skippabcool]

The ugly

[thtrog]

Ouch, what happened???

[skippabcool]

It was a little bent when I bought the boat and could never figure out how them bent it. I did not hook it up to the fak a lake since we were headed there. I left it hooked up to the trailer and started it to make sure there were no issues. When I went up to unhook I saw them metal bending like it was nothing. When I hooked it up after we were done it did the same thing and moved after it came out of the water.

[skippabcool]

I am hoping that they can maybe lift the boat heat it and straighten it then add some re enforcement. Or they might have to cut that whole section off and put a new one on.

[skippabcool]

Skippa how did the water test go?

Ballast was good.

[thtrog]

I've never seen that, but see how it could happen. I wonder if the previous owner bend it loading.

[thtrog]

bent*
should not be too bad to fix

[Wakeman22]

Ouch! I don't think that heating and bending will be the best idea. I would cut it off and weld in a new piece. Something thicker so it will not happen again.