Im lost without the PW thread!!!!

[bryce2320]

Haha I bet

[Wakeman22]

I only have another 150 or so sheets to hang. @7 are 12 foot pieces.

[Wakeman22]

And yes those waves are huge.

[bryce2320]

Spend the time and run the wires like a pro does.

Lol, definitely will. It was funny the thought of wires zip tied to the tower tho

[bryce2320]

[chpthril]

Best picture I can find of what I'm talking about

The forward upright does not pass through to the lower bar. its bolted and acts as a hinge. You would have to pop out with a service-loop, plus a disconnect, and then pop back into the lower support bar. You would then have to pop out of the lower support bar just above the foot and go through the deck.

[Wakeman22]

Bryce remember to chase the wires you can start with a piece of string and blow it through the bar with air, then pull a stronger wire and finally the speaker wires.

[bryce2320]

Mounting this extra pair of rev 10s has been stressing me out. Just because I remember how pissed I got running the first 2, and the wires were already in there to pull with

[chpthril]

Survivor starting

[Wakeman22]

How do the current wires run?

[bryce2320]

The forward upright does not pass through to the lower bar. its bolted and acts as a hinge. You would have to pop out with a service-loop, plus a disconnect, and then pop back into the lower support bar. You would then have to pop out of the lower support bar just above the foot and go through the deck.

There's a hole thru the deck under the tower foot so it'll b hidden. I remember taking the foot off to drill the hole bigger so the wires would fit would popping out of the tower at the front bar to the lower bar look like I garbage? Even if I run the expanda loom or whatever to cover them?

[bryce2320]

How do the current wires run?

Down the port side of the tower, then pops out at the bottom to go in the lower bar and thru the deck.

[Wakeman22]

Just follow the same path just on the starboard side.

And yes that was funny. Zip tied. Ha Ha Ha

[Wakeman22]

Zip tied. That's so gehto.

[chpthril]

There's a hole thru the deck under the tower foot so it'll b hidden. I remember taking the foot off to drill the hole bigger so the wires would fit would popping out of the tower at the front bar to the lower bar look like I garbage? Even if I run the expanda look or whatever to cover them?

Oh ok, I was thinking that the foot and tower end on that model was solid.