If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Remember when I said that as a bonus my factory hard tank drain was drawing water through the vent line from the big sack and helping to speed up the drain? Well, I discovered yesterday that I've got passive draining of my big sack through the factory hard tank and out the drain of the factory hard tank. Today I get to change my steering cable and buy more hose and route the factory hard tank drain hose to the opposite side of the boat too.
2009 RZ2, PCM 343, MLA Surf Ballast, Premium Sound.
2013 Toyota Sequoia 4WD W/Timbren SES
Bruizza your a Ronix guy, my sons 9 - 11.5 2011 Kai OT bindings fit good dry but when they are wet you can't get a size 10 or 10.5 in them. They are the material so I didn't think or want to add the slime to them. Any idea how to make it easier to get into them?
Bruizza your a Ronix guy, my sons 9 - 11.5 2011 Kai OT bindings fit good dry but when they are wet you can't get a size 10 or 10.5 in them. They are the material so I didn't think or want to add the slime to them. Any idea how to make it easier to get into them?
Bruizza your a Ronix guy, my sons 9 - 11.5 2011 Kai OT bindings fit good dry but when they are wet you can't get a size 10 or 10.5 in them. They are the material so I didn't think or want to add the slime to them. Any idea how to make it easier to get into them?
That is odd mine usually go on easier when they are wet. I do notice when they sit in the sun all day they shrink up some and are harder to get on but you seem to have the opposite problem. That boot slime stuff is supposed to be safe for all bindings though. I got nothing though on how to actually solve that issue.
Comment