So after I came off the water and sauced my boat, I noticed the trailer was looking a bit dirty, so when I got home I washed, polished and waxed the trailer to make it as pretty as the boat. While I was up close buffing the paint I notices a crack in a weld that might have been there for a little bit, it's a little rusty. This picture was taken with a flash so the crack looks a little worse than it is. Then I looked under the swing tongue area to see what else was cracked, and that is the second picture. The cracked welds are on the sides of the center beam so at least I can take it to a welder tomorrow morning and not worry about breaking down, and it's back roads to get there, and it's only 3 miles away.
Anyway, in light of recent trailer safety and inspection and dissapointment of Road Runner trailers, look your over very well. I've got some other welds that I don't trust either so I'm getting a lot redone tomorrow.
Anyway, in light of recent trailer safety and inspection and dissapointment of Road Runner trailers, look your over very well. I've got some other welds that I don't trust either so I'm getting a lot redone tomorrow.
Comment