Announcement

Collapse
No announcement yet.

Replacing trailer bunks..

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Replacing trailer bunks..

    I just recently purchased a '08 22ve that's mechanically solid (so far), but needs a lot of TLC. I put together an intro thread here: https://www.tigeowners.com/forum/gen...oducing-myself

    Part of the TLC was replacing the bunks ASAP after we got the boat home. While testing the boat, I checked out the trailer, and one of the bunks was so rotted we had to rubber band it to the trailer mount just to get the boat back on the trailer.

    I built up a full set of bunks from 2x4 and 2x6 treated lumber and stainless hardware. I countersunk the hex head bolts, then locked them in place with 5 minute epoxy. For bunk carpet I went with Cuda Powersports 12" and 18" rolls, plus a box of staples. I bought a pneumatic stapler from Lowes for ~$40, plus 2 cans of 3M 90 spray contact adhesive.

    Assembly went well, taking my time and about 4 hours of work. Then we dropped the boat in the water, and proceeded to Go. To. War. on the old bunks. I used a pipe wrench, 18" slip joint pliers, locking pliers, and a 16 pound sledge hammer to "adjust" the mounts back to their proper location. It took about 3 hours, an aggravated rib injury, and sore muscles everywhere else. The non-stainless hardware had corroded away so badly that I literally had to use the pipe wrench to tear the old bunks apart so I could get to the hardware. Looking back, it would have been a great idea to have a battery powered angle grinder/cutting wheel to cut the old hardware off.

    Why were the mounts bent? Only thing I can figure is the previous owners didn't get the trailer deep enough when getting the boat on the trailer. I can only imagine the loads a modern surf boat puts on their bunks!

    At the end of the day, I now have the boat on a good set of bunks, and I can work on through the off-season. (and yes, I know many of you break the ice on the lake so you can keep skiing, but I'm a wimp).

    IMG_1870 resized.jpg
    IMG_1871 resized.jpg

    Y'all have a good one,
    Mike

    #2
    I will be doing the same thing soon to my trailer bunks. Good idea to have cordless tools with you!

    Comment


      #3
      On my last trailer the bunks were intentionally bent to get the wood to flex and match the contour of the hull. More so on Tiges there is little area that is flat except at the back.

      Comment


        #4
        Originally posted by h2o-ski View Post
        On my last trailer the bunks were intentionally bent to get the wood to flex and match the contour of the hull. More so on Tiges there is little area that is flat except at the back.
        If you look at the photo of the finished product, there's only 2 bunks that have 3 mounts where you could flex the wood, and those are on the back where the hull is flat. I expect the other bunks will flex as needed to conform to the hull.

        Comment

        Working...
        X