2006 vs 2007 20V's

[wannab0133]

swivel racks

How much would it cost approximately if I were to purchase swivel board racks for the 2006 20v? While were at it, how much does the mirror arm assembly run also? The one I am looking at dosent have the swivel racks. Also, the teak swim platform has some scratches and one side is starting to slightly peel up. Is that something that I should worry about, and maybe get something off of the price for? Below is a pic, and the problem area is on the left.

teak picture.jpg

[chpthril]

How much would it cost approximately if I were to purchase swivel board racks for the 2006 20v? While were at it, how much does the mirror arm assembly run also? The one I am looking at dosent have the swivel racks. Also, the teak swim platform has some scratches and one side is starting to slightly peel up. Is that something that I should worry about, and maybe get something off of the price for?

I'm 95% sure that the 06 20V's had swivel racks on the factory tower

Should be able to call your nearest dealer and get a price. There are some aftermarket racks out there also.

Mirror: look on Ebay, there are a couple of good arm/mirror set ups out there.

Personally, I would not worry about light scratches in the teak, but de-lamination should be something to think real hard about.

[jwanck11]

Is it a layer of the "teak" that is pulling up or a whole board that is separating?

[lee]

In 2006 the swivel racks were not standard but an option. The platform could be reconditioned and the raised board glued and screwed down.

[wannab0133]

thanks

The racks are not the swivel racks, so i need to replace them and the seller knows that. I just dont know how much(ballpark) it will cost me. My tige dealer here is bad, they never answer the phone and if they do they always say they need to call back and they never do. I go by there, and the place is empty, and the guy there never knows anything. Also, I will need the platform reconditioned, but I need to know how much that will cost me. Also, Im not sure I want the teak screwed down, b/c I assume you'd see a screw. I am not sure if it's a layer or the whole board, as I have not seen it in person yet. Any ballpark figures?

[lee]

The platform is already screwed from the bottom, you would just add another from the bottom also. Glue, clamp it down tight, the put a stainless steel screw in it.