Shower location

[flackpack]

here is the tee installed

[flackpack]

Install your pump. I placed mine in the starboard compartment in the rear. I Mounted the pump to the backside of the aft bulkhead below the opening.

[flackpack]

The factory pre-wires a shower toggle on the dash, and the wiring is active to this compartment. The wiring is very straightforward, and takes all of about 2 minutes. I used waterproof wire nuts.

[flackpack]

Next we cut out an opening in the factory door opening and installed the shower box. On the back side we waterproofed the wood and re-covered it with I/O carpeting and the original welting.

[flackpack]

We then plumbed hot water port to hot connection, cold to cold and combined to the new pump. From the pump out to the shower head.

[flackpack]

Cold water out of motor

[flackpack]

Shower connections

[flackpack]

Then close up the compartment, and you have a shower. I also placed a lock on the door to keep it from opening and allowing quick service entry if needed.

[flackpack]

Closed view with original door pull replaced

[flackpack]

view of size in cabinet. Also the showerhead hose is 8' long to allow easy access from the swimstep.

[flackpack]

and the engine box is now back to normal with shrouds in place, and all hoses out of view and out of the way for the belts and pulleys.