Wont go into reverse

[whiteflash watersports]

2012 RZR pcm 343 will not shift into reverse. Was out for a few hours everything is fine return to the dock and no reverse. Engine just revs in reverse. Goes into forward gear fine.

I have checked all of the linkage and fluids are fine. Any thoughts? How much $ am I looking at?

[freeheel4life]

I would disconnect the cable and manually try to shift it at the trans with the floor lifted.

[whiteflash watersports]

Ok I will try that. When I had the floor lifted and was looking it appeared to shift. If it shifts in to reverse manually what next? Replace the cable?

[freeheel4life]

Yes or possible adjustment. If there's loose linkages at the throttle end it could not be pushing the shift lever far enough to let fluid thru the valve. Its a quick easy check before jumping to a worst case scenario.

[admorrow]

Had the exact same thing happen to my 09 rz2 last weekend with the IRM40-1S the linkage appeared fine I'm going to try to disconnect it and manually move it. Although it makes a squealing noise in reverse and a slight noise as soon as forward clutches are applied.

[whiteflash watersports]

Mine works fine in forward and revs and revs in reverse. No weird noise at all.

[KoolAid]

Had the exact same thing happen to my 09 rz2 last weekend with the IRM40-1S the linkage appeared fine I'm going to try to disconnect it and manually move it. Although it makes a squealing noise in reverse and a slight noise as soon as forward clutches are applied.

Could be just squealing on a dry cutlass bearing. Spray wd40 in it on the strut and see if it dampens the squeal or not.

[njhogle]

Hello all! My 2003 24V is doing the same thing. Did you ever figure out the issue?

[chpthril]

Need to see if this is a mechanical issue with the lever or cable, or a hydraulic issue within the trans.

Release the cable from the trans, then move the trans lever manually is step one. If it goes into reverse, then it looks like a cable or lever issue

[whiteflash watersports]

Update - Found out today transmission is toast. Was hoping it was the pump but no luck. Gonna be $2600 with parts & labor. Not really sure if that os good price or not. It is 2012 pcm 343