Perfect Pass Install on 23V

[RZMike]

I'm getting ready to install perfect pass on my 23V, but I'm a little unsure of where to put the paddle wheel. I've read all the posts about avoiding spots with turbulance, bunks, ect. The instructions say "as near centerline as possible", but I don't see how I can do that with the tracking fins, prop, and propeller.

Anyone have a picture or can take a picture of the underside of your boat so I can get an idea of a good spot?

[Matt Garcia]

Mike, I think I may have a picture at home of my paddle wheel placement.

I will see if I can find it.

[dschock]

I think you're a little confused about the directions. I have read through my instructions a few times, just anxious to get the boat out of storage so I can install my PP.

Here is an excerpt from the installation manual on the PP website... they're the same as what I have:

V-DRIVE / WAKEBOARD BOATS / STERN DRIVES – The paddle is typically installed in front of the engine, just behind the gas tank. (This area is generally accessible from the engine compartment or under rear seat.) It is installed typically 7 – 8 inches off center, clear of any strakes in the hull, depth sounders, etc. Refer to any addendums that may be included. Never install behind a water intake or any other item that could cause turbulence.

Matt, it would still be nice to see that pic though. Thanks.

[Matt Garcia]

Mike, sorry I dont have a picture.

If memory serves me correctly the paddle wheel was placed on the left side of the engine and about 9 inches from the front of it.

Hope that helps.

[RZMike]

Thanks for looking Matt.

dschock - My instructions say "Locate amidships near the centerline"