I'm looking for pictures of the seat blocks under the port observers seat. Especially on '07 RZ2s, but any and all other years would be a huge help also.
Thanks,
Todd
Thanks,
Todd
-
-
Bueller, Bueller...anybody? -
I'm trying to figure out what a "seat block" is... Do you have a link of what you are talking about???Comment
-
Are you talking about the "underside" of the seats?Comment
-
^^^ If that's it, then I understand now and can take a picture later today.Comment
-
Are you talking about that foam/rubber block that keeps the seat cushion from sliding out?Comment
-
sorry I wasn't more specific, but you guys got it. The two foam blocks under the observer's seat that keep it from sliding around. Thank you guys for understanding! Pictures of those would be a huge help.
Comment
-
^^^ Great.. I have to get into my boat tonight to clean it anyways. Will take the pictures at that time.
Comment
-
Fantastic!Comment
-
Here you go. The measurements were from the inside "ribbon". Add another 1.5 inches and that is where the blocks should be. Any questions, just ask.
Comment
-
But, I think the best bet would be to keep the seat in it's place and crawl into that area from the bow and mark the blocks where you want them placed while the cushion is where it belongs.
hahaha, I see that I am missing a piece on the bottom of the seat
Comment
-
It looks like in picture dsc04349 that the vent cover/drain is missing where you can see the foam. Probably A cost cutting measure in 07 models.
Comment
-
Thanks da! That's exactly what I was looking for.Comment
-
No, just have to silicone it back in. Fell off last season and I forgot to put it back.Originally posted by MoneyPity View PostIt looks like in picture dsc04349 that the vent cover/drain is missing where you can see the foam. Probably A cost cutting measure in 07 models.
Comment
-
You are welcome.Originally posted by BrownClown View Post Just let me know if you want any more measurements. Didn't quit make it into the boat yesterday to clean. 
Comment
Comment