stripper pole help...

[Lucky 275]

Wish I knew what a stripper pole was...




would it fit where the table should go?

[kana12]

thats a thought. i dont see y it wouldnt.. would that be stronger?

[kana12]

see i would like to run it all the way through the floor but the rear pylon is nothing more than a small piece of the pylon then has a piece of all thread that sticks through the hole and gets a nut on it. i doesnt run all the way down. i guess i could make the hole bigger and make a bracket.

[kana12]

or what if i let the all thread go all the way to the floot and connect that to a bracket

[chadster2]

I’ve put them in a bar before…..
Think moment arm or pry bar……. it will fail with enough beer.

Through to the bilge area
or best is
floor to tower with seats around it.
the pole has a slip fitting up top and a floor ring it slips down into with a pin
that way the pole can spin

[Domsz06]

have seen the stresses, not sure I would put one on unless it's mounted to the tower as well....

[Fast1911]

i have nothing to say.....................yet

[Lucky 275]

[QUOTE=kana12;323244]thats a thought. i dont see y it wouldnt.. would that be stronger?[/QUOTE

now that I think about it, probably not. That seatbase is really flimsy. I think you would have to make a stronger sleeve that goes down and sits above the vdrive and then brace the sleeve to the stringers. Then, slide the pole into the sleeve.

[philwsailz]

I had one on my last boat. It was basically a converted pylon and made for some fun, fun evenings.

Been there, seen that.

Amen B, that was some fun times...

Don't let him fool you, there was more than just a pole in OB's boat. I remember a mirrored ball once with some wild-a$$ lighting too...



Guys-

If you want the ultimate dancing pole, get a sailboat....

[dogbert]

Guys-

If you want the ultimate dancing pole, get a sailboat....

I thought the same thing as they were trying to figure out how to mount it.

[kana12]

i guess ima have to find another way.. maybe i can mount it to the tower if i were to mount the pole like a 6 in behind the toer and made a bracket to run from the top of the pole to the tower then it would be just right infront of the 485.