If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
White webbing with buckles and short pole go up front in bow, black straps with loops and tall pole in main cabin, single strap connecting the plastic pole caps goes over windshield. Front straps will loop through the front cleats (I believe) and the rear loops through the rear cleats. Tighten the Fast-Tec buckles so everything is taut.
Mikes Liquid Audio: Knowledge Experience Customer Service you can trust-KICKER WetSounds ACME props FlyHigh Custom Ballast Clarion LiquidLumens LEDs Roswell Wave Deflector And More
Both poles should rest on floor. If the rear loops will not reach and the buckles are loosened up, move the white straps to the front half of the hand rails.
Mikes Liquid Audio: Knowledge Experience Customer Service you can trust-KICKER WetSounds ACME props FlyHigh Custom Ballast Clarion LiquidLumens LEDs Roswell Wave Deflector And More
chpthril--Man you just have all kinds of answers today
I think I will have to play with it somemore
right or wrong, I got'em
Mikes Liquid Audio: Knowledge Experience Customer Service you can trust-KICKER WetSounds ACME props FlyHigh Custom Ballast Clarion LiquidLumens LEDs Roswell Wave Deflector And More
connect the rear black ones first, then adjust the front white ones so that they will be tight. The cover for the Z tower always seemed to allow some water to gather on top of it in the back right behind the windshield also.
I played with my pole(s) yesterday and got it all figured out. I was mistaken, the webbing coming off the aft pole is long enough to go to the aft cleats.
Comment