If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
WOW SPBFAN is the man. My new sensor showed up today. I called everyone on the planet friday but no one had one. Andrew hooked me up by calling PCM and having it at my house today
Ok finally got out to test the new sensor. The sensor seemed to work all be it the motor did not suddenly shut down but it ran like CRAP. Could got get past 10 mph and was running very rich. could smell the gas. It was like it was flooding out and had now power. Motor was running ruff .
Once I got it home I tested the spark on all plugs. The right bank of 4 was noticeable less. The spark was more of a yellow and the other bank of 4 was a nice white strong spark. there was some misfiring and back firing around 2k rpm and at idle the was a noticeable stutter. It seemed to dropping cylinder on the right side.
Bad ECM? since I could not pin point it to one cylinder I am not thinking coil module.
Comment