17" Drop Ball Mount

[kana12]

he can use a a floor jack or something.

[tessa]

How are you planning on getting the tounge onto the hitch ball. My Trailer jack is at least 12 inches high when it is jacked to the lowest position?

My boat jack goes lower than that but just in case I have a floor jack that is about 6-7 inches high which I cn put under the V of the trailer. That is the least of my problems but thanks for bringing it up.
There is always something.
If it wasn't for the price I would not have been interested and I really did not want a tower but did not ant to leave holes to be filled in the tangerine color. They would not match so we kept the tower.Damn

[xpjim1]

he can use a a floor jack or something.

Good answer.

[Lucky 275]

I put 185 R14 trailer tires on my trailer had the trailer lowered. I put my boat in and out of my garage with a Craftsman 5000 lawn tractor and it squeezes under my 82.5 inch door. It's a 06 22v with a dorsey trailer.

[tessa]

I put 185 R14 trailer tires on my trailer had the trailer lowered.

We modified the length of the trailer so length wise it will fit. It was supposed to modified to 20' 5" and they were closer to 21' 5" so that is getting corrected. Next they are lowering the bunks by 3" to reduce the pivot point on the tower to 83.5 inches which is low as the trailer can go due to prop, fins, rudder, and running gear. Next when we put the trailer in and out of the garage we are putting an 11" drop down with a 2" ball to drop the tongue further so that the towers front mirror and pivot point should clear the garage door sill opening which is 82.5 inches.

Wish me luck and thanks to all who have contributed to this thread.

[kko]

ive seen the one on the wetsounds set up its pretty sweet

[tessa]

Good answer.

And I actually have a floor Jack and a hydraulic single pole so I should be good