Installing Perfect Pass

[da.bell]

Moki, when are you going to do the How To write-up on "How to get the Ball and Chain to let you spend all this money on your boat"

I second that write-up request!!!!!!!!!

[zad0030]

Yeah it might pass up the 3 word post whores thread in # of posts

[xpjim1]

Mine is on the starboard side

[talltigeguy]

I think the hardest part is installing the paddle wheel.

Actually, I think the hardest part by far is getting it attached properly to the throttle.

Drilling holes in the boat are old hat for me...If I goof up, just cover it with some duct tape and silicone sealant.

Mine is on the starboard side, but have seen them on the port side too. My gas tank is a little bit shaped like the state of Utah, so I wish that the PP were on the same side as the tongue on the gas tank, which would have left a little more room for the ballast manifold on the other side.

I wanted to quote more than one person on another thread...How do you do that? I hit the quote button on the bottom of someone's comments and I get the box to write in, but do not know how to go get another quote by another person. Help!

[zad0030]

I wanted to quote more than one person on another thread...How do you do that? I hit the quote button on the bottom of someone's comments and I get the box to write in, but do not know how to go get another quote by another person. Help!

Hit the small button right next to quote on the posts you would like to quote and then press Post reply.

[da.bell]

Hit the small button right next to quote on the posts you would like to quote and then press Post reply.

What he said.....

[chpthril]

Hit the small button right next to quote on the posts you would like to quote and then press Post reply.

Actually, I think the hardest part by far is getting it attached properly to the throttle.

Drilling holes in the boat are old hat for me...If I goof up, just cover it with some duct tape and silicone sealant.

Mine is on the starboard side, but have seen them on the port side too. My gas tank is a little bit shaped like the state of Utah, so I wish that the PP were on the same side as the tongue on the gas tank, which would have left a little more room for the ballast manifold on the other side.

I wanted to quote more than one person on another thread...How do you do that? I hit the quote button on the bottom of someone's comments and I get the box to write in, but do not know how to go get another quote by another person. Help!

Mine is on the starboard side

Like this........... cool, I never knew that, thanks Zad

[Domsz06]

yeah I had to learn how to that the other day as well!

[Domsz06]

I don't have to get permission to spend money

[da.bell]

I don't have to get permission to spend money

Arse!!!!!!!!!!!!!!!!!!

[Domsz06]

he he he!

[chpthril]

I don't have to get permission to spend money

yeah, But we don't have to buy them dinner before.............

[da.bell]

yeah, But we don't have to buy them dinner before.............

No, just a house!!!!!!!!!!!

[Wake Bandits]

And the hardest part of that is drilling a 2 inch hole in the bottom of your boat!

Yea there it is.
A lot of huevos to make that cut.
We calibrated ours with a GPS, it was about 9MPH outta whack out of the box.
Seem'd to do the trick.

Its added value to the boat is excellent.
A good investment.

[Domsz06]

i don't buy them dinner either!